You can monitor and change
the memory under given address. But change of memory is available only
for RAM memory.
Note that only visible items are
updated to reduce the communication burden of MCU. So, please minimize
the window size so that the communication burden of MCU could be
also minimized.
easyDSP limits the address range according to MCU. In case the
adress is limited by easyDSP, the data of address is displayed as '-'
without reading.
NOTE :
1. For Arm core MCU, HardFault is
caused by accessing an invalid address (which is not limited by easyDSP).
Please be careful when setting the address.
2. For a certain STM32 MCU with secure MPU
activated, MCU can be stuck after memory access.
This window displays a memory
with hex format and variable bit width (8/16/32 bits).
To change
its value, first select the row and click left button of mouse in the target
location.
Versatile address input is available such as
0x1234 (hex), 1234 (hex without 0x prefix) and &variable.
Also comment (//) can be added to the address input such as
'0x1234 // register'.
In
the address combo box, the recent addresses are registered so that
you can easily swap between.
Total memory size to be displayed in a
window is 1kB (0x400). But regular data update is limited to only visible area
of window.
Note :
1. The start address is 4B aligned for
TI C2000 MCU.
example) if
input address is 0x--0 or 0x--1, then start address
is 0x--0.
example) if input address is 0x--2 or 0x--3, then start address
is 0x--2.
2. The start address is 8B aligned
for Arm core.
example) if
input address is 0x--0 to 0x--7, then start address
is 0x--0.
example) if input address is
0x--8 to 0x--F, then start address
is 0x--8.
3. The first
memory address shown in the window could be not the address you
input in the adress combo box.
4. 1kB memory area is displayed from
the start address.
5. In case
&var format is used as an address input, if it is changed with code
modification, the address of the window is automatically changed after MCU
booting.
